#1
|
|||
|
|||
2004 Quest transmission pan removal
Any suggestions on the best way to remove the transmission pan on my 04 quest 4 speed AT? It looks like one of the bottom supports is blocking access to 2 or 3 bolts on the pan. I have not tried squeezing a wrench in yet but was curious on how others have removed it. I am getting the PO745 code along with an occasional 1 - 2 hard shift. It seems to occur only when leaving a driveway or if I hit a bump. I read in a TSB a wire may need to be re-soldered. The warranty expired 20,000 miles ago.
Last edited by tdelmer; 10-10-2007 at 03:57 PM. Reason: addition of information |
#2
|
||||
|
||||
Quote:
__________________
SHOW YOUR SUPPORT!
Subscribe FIND OUT WHAT YOUR REPAIR SHOULD COST? Repair Cost Estimator BUY NISSAN ACCESSORIES! Nissanhelp Store |
#3
|
|||
|
|||
FYI
It took a 10mm offset boxend to remove the bolts. The loose wire was identified and soldered. Problem fixed.
|
#4
|
|||
|
|||
Sorry you might not have the car anymore but how did you get that last bolt out.. It seems that a 10 mm box end wrench will not fit.
|
Tags |
2004, pan, quest, removal, transmission |
Thread Tools | |
Display Modes | |
|
|