Nissan Expert advice please
Good day, I have a 2018 Nissan Frontier 2.5l NP300, 60 000km on the clock. it keeps going into limp mode when I reach 3000rpm. the only error I get is P012B. can this cause the limp mode and how can I fix it?
We tried replacing the Solenoid Control Valve on the pump Replaced the Pressure Release Valve Any and all advice will be appreciated! |
Unfortunately, we don't have the 2.5 diesel engine in the US. The P012B code can be triggered by the following:
-Faulty Turbocharger/Supercharger Inlet Pressure Sensor -Turbocharger/Supercharger Inlet Pressure Sensor harness is open or shorted -Turbocharger/Supercharger Inlet Pressure Sensor circuit poor electrical connection Read more: P012B Turbocharger/Supercharger Inlet Pressure Sensor Circuit Range/Performance Downstream Of Throttle Valve I would believe that it could cause you to go into limp mode. I did find that there are several YouTube videos that have diagnostic information pertaining to this code for this application, so that would be a good place to start. You should check the harness connections in the circuit to make sure the pins are clean, straight and not pushed out of the connector. Ideally, a factory service manual should be accessed where you can find the step-by-step diagnostics for that particular code along with the wiring diagrams, but I don't know of any places to access FSM's for vehicles outside of the US. |
All times are GMT -8. The time now is 01:00 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Search Engine Optimisation provided by
DragonByte SEO v2.0.42 (Pro) -
vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.