#1
|
|||
|
|||
consult II
will consult II tell dealer if remote control signaller is accepting signal from remote
|
#2
|
||||
|
||||
No, they will probably recommend another remote. Try one more thing, disconnect the car battery and try reprogramming the remote again, make sure all the doors are fully close (including the back door and hood) and that you closely follow the instructions.
We'll get the remote working.
__________________
Need A Repair Shop? Find local automotive repair shops in your area. AutoCodes.com Shops |
#3
|
|||
|
|||
thank you
But I did that twice already with same results I have both Model A and 01A and still no results according to service manual the controller is in SEC unit
|
#4
|
|||
|
|||
remote no go
Tried disconnect one more time just for fun but NO go
|
#5
|
||||
|
||||
Questions:
1. Does the dome light turns off when you close all the doors? 2. Does the "Security Light" start blinking when you open one of the doors? 3. When you go inside your vehicle and close all the doors to start reprogramming the remote, does the "Security Light" turns OFF or keeps blinking? |
#6
|
|||
|
|||
Dome light off when I turn key/security blinking during programming
|
#7
|
||||
|
||||
Quote:
|
#8
|
|||
|
|||
consult
Thanks that tells me a lot now I know where to start this was crazy. Do I need a testor to check them or is there another way and why did Security work OK when tested?
|
#9
|
|||
|
|||
Security light
My light goes off only after reaching ACC w/key in ign
when is it supposed to go off and why does program lights flash Is there anything in service manual for this. Switches look OK |
#10
|
||||
|
||||
Key out of the ignition:
Door(s) Open: light blinking All Doors Close and Unlock: light OFF All Doors Close and Lock (Security System Arm): Light ON for about 30 seconds and then blinking. Quote:
You should download the "Electrical System" section of the service manual, all the inofrmation is there. You can download the section free from here: Knowledgebase - 2001 Pathfinder - Nissanhelp.com |
#11
|
|||
|
|||
security
open each door checked switch and press to have interior light go out even hood seemed to work OK was that correct got it from forums/ Is there a way to reset system other than Battery cables The systems been this way the whole time I had the truck. Is Smart Entrance the culprit or something else.Already have Electrical thats why I though system was OK , followed chart and everything
|
#12
|
||||
|
||||
When you go through the programming procedure do the hazards flash? If they do then you either have the wrong remote or the remote is no good.
__________________
Nissan Master certified Technician
Hybrid and GTR certified EV certified ASE Master Certified. |
#13
|
|||
|
|||
All Doors Close and Unlock: light OFF
All Doors Close and Lock (Security System Arm): Light ON for about 30 seconds and then blinking. When I go to program instructions it say lock doors, doesnt security light go on for programming mode? |
#14
|
|||
|
|||
To check system I took apart hood switch and drivers door to try to overide switch but blinking still happening. Could there be a short somewhere?
|
#15
|
||||
|
||||
Quote:
Quote:
|
Tags |
consult |
Thread Tools | |
Display Modes | |
|
|