#16
|
|||
|
|||
As soon as doors are locked I start key insertion and get flashing hazards but nothing afterwards with regard to switches I have checked all 6 with interior light and removed DS door and hood is there a way to bypass each to see if one is not working correctly
|
#17
|
|||
|
|||
do the doors and hood relay to SECU that the car is unlocked or just open and closed and can I check with voltmeter
|
#18
|
||||
|
||||
Are you turning the ignition on after the hazards flash?
__________________
Nissan Master certified Technician
Hybrid and GTR certified EV certified ASE Master Certified. |
#19
|
|||
|
|||
I turn ignition to ACC first then to ON but dont get flashers on either remote both were checked OK by dealer but now im told the security light should be off and I dont understand because when you turn to ACC the security light is supposed to come on Security system checked OK according to Electrical downloaded from this site.How do I get remote to work
|
#20
|
||||
|
||||
Quote:
|
#21
|
|||
|
|||
Im sorry but I have done both have do not get second flashers Does Security system have anything to do with it?
|
#22
|
||||
|
||||
Are you sure you have the correct remotes. There were 2 different frequency remotes for that model. If the module was ever changed for any reason you could have ended up with the wrong frequency remote.
|
#23
|
|||
|
|||
yes I have both Model A and 01A the VIN called for one and this site recommended the other neither work. my production date is 2/00 2001 Pathfinder 3.5L
|
#24
|
||||
|
||||
Try disconnecting your battery for about 15 minutes. This works sometimes. Usually if you get it into program mode(initial hazard flash) they will program without any problems.
|
#25
|
|||
|
|||
Sorry tried that 3x
|
#26
|
||||
|
||||
what is the exact procedure you are using to program the remote? Step by step
|
#27
|
|||
|
|||
From Electric download -Close door w/switch insert key 6x then I get flashers turn key to ACC first push button on one remote then other then try Lock/unlock then try other remote just in case then try ON/thanks for your time Ill try again tommorrow
|
#28
|
||||
|
||||
Quote:
1. open the drivers door and start the truck 2. Turn off the engine then close the drivers door 3. Lock the doors using the power lock button on the drivers door. 4. Insert the key in and out of the ignition 6 times or until hazards flash 5. After hazards flash turn the ignition all the way on to run (not accessory) 6. Press a button on the remote and watch for hazards to flash. 7. If hazards do not flash unlock and relock the doors using the power door lock switch. 8. Press a button on the remote again and watch for hazards to flash. 9. If hazards do not flash turn off ignition and unlock and open the door. Now check to see if the remote is working. Sometimes it will take the program without the hazards flashing. If you still can't get them to program try turning the key in the door locks and the tailgate lock(lock and unlock all of the locks) and then repeat the steps. If none of that works you may have a bad smart entrance control module. |
#29
|
|||
|
|||
do u know part number for SECU?
|
#30
|
|||
|
|||
will consult testor determine if entrance unit is defective?
|
Tags |
consult |
Thread Tools | |
Display Modes | |
|
|