#1
|
|||
|
|||
2006 altima ac clutch bearing
can you replace the ac clutch bearing vs entire clutch? if so are there any instructions / videos available.
|
#2
|
||||
|
||||
The bearing may not be available, but here is are the instructions to replaced the A/C Compressor Clutch on a 2007 Nissan Altima 2.5 in case you need it.
__________________
Need A Repair Shop? Find local automotive repair shops in your area. AutoCodes.com Shops |
#3
|
|||
|
|||
Thanks. another question have clutch to point of pulling off from compressor but clutch will not come off. Have try to pry turning clutch 180 degrees, and have not been able to get it come loose. Any suggestions.
|
#4
|
||||
|
||||
Did you removed the snap ring? If you did you could try using some WD-40 and let it soak for a few minutes to get it loose. Here are the instruction from the service manual:
|
#5
|
|||
|
|||
2006 nissan altima 2.5 compressor clutch
It appears there is another snap ring inside clutch shaft. Is this correct?
|
#6
|
|||
|
|||
06 Altima compressor clutch coil
Will this coil operate correctly? I have attached a pic. It appears the insulation has deteriorated.
|
#7
|
||||
|
||||
Quote:
I don't think so. It doesn't look good. |
#8
|
|||
|
|||
When removing the clutch / coil I found there are 3 what appear to be very thin round washer type shims. The video does not reference or show these shims. How are they installed.
Thanks |
Tags |
2006, altima, bearing, clutch |
Thread Tools | |
Display Modes | |
|
|