#1
|
|||
|
|||
Altima O2 Sensor P0132
Hi, I have a Service Engine Light on with the code P0132 -> O2 Sensor Circuit High Volts (Bank 1 Sensor 1). I have changed the catalytic converter and the upstream O2 sensor and reset the code. Drove for a while the same code came back again.
Does anyone know how to fix this? Thanks much! Last edited by Eddie2018; 01-25-2018 at 05:38 PM. |
#2
|
||||
|
||||
If you have already change the sensor and the code comes back, then you may either have a broken or short wire.
Also, have you tried clearing the mixture ratio self-learning? 1998-2012 Nissan Altima Clear Mixture Ratio Self-Learning Control Data Read more: 1998-2012 Nissan Altima Clear Mixture Ratio Self-Learning Control Data | Nissanhelp.com
__________________
Need A Repair Shop? Find local automotive repair shops in your area. AutoCodes.com Shops |
#3
|
|||
|
|||
Hi NissanTech,
Thanks for the help. I have tried multiple times but I got more code coming up instead of erasing the P0132. I did not get the P0102 at all. After trying your steps, I got P0132, P0031, and P0171. P0031 can be erased but the P0132 and P0171 keep coming back. Is there anything I can do? Thanks. Eddie Last edited by Eddie2018; 01-30-2018 at 04:11 PM. |
#4
|
||||
|
||||
Do you have 4 or 6 cyl engine?
Other than exhaust leaks and the sensor itself, I haven't seen any other component triggering those codes. The next step is to check the wires from the sensor to the Engine Control Module (ECM) and power. Start by checking the fuse from the IPDM to the sensor., fuse #46. |
#5
|
|||
|
|||
Hi NissanTech,
I have 4 cylinders. I have checked the fuse and wiring. All are good in condition. I have erased the code and I am having P0171 and P0301 right now. I purchased the O2 sensor from EBay and it is not OEM part. Does Nissan just recognize the OEM O2 sensor? Or is the P0171 and P0301 are causing the P0132 to fail? By the way, I have monitor for below status. Is this something better for you to see what happen with my car? MIL = ON MISFIRE = READY FUEL = READY CCM = READY CAT = NOT READY HCM = N/A EVAP = NOT READY 2AIR = N/A A/C = N/A O2S = NOT READY HO2S = READY EGR = N/A Many thanks. Eddie |
Tags |
altima, p0132, sensor |
Thread Tools | |
Display Modes | |
|
|