VARIOUS NISSAN MODELS; FUEL TANK IS SLOW OR DIFFICULT TO FILL
The fuel tank is slow or difficult to fill (filling nozzle shuts off before tank is full).
VARIOUS NISSAN MODELS; BALL JOINT AXIAL END PLAY PROCEDURE
When working on the front suspension, use the updated service information in this bulletin along with the Electronic Service Manual (ESM).
VARIOUS NISSAN MODELS; FRONT SONAR PARKING SENSOR SERVICE INFORMATION
When diagnosing the front sonar parking sensor for unwanted activation (e.g. sonar activates with no obstacle ahead), inspect the front license plate, front license plate frame and if equipped, the front license plate bracket.
VARIOUS NISSAN MODELS; NISSAN INTELLIGENT KEY REPLACEMENT OR SWAPPING BETWEEN VEHICLES
The Intelligent Keys used on the various Nissan vehicles may not be interchangeable between models and years.
2005-2008 NISSAN PATHFINDER, FRONTIER, XTERRA WITH V6 ENGINE; SERVICE INFORMATION FOR REMANUFACTURED A/T FROM ATC DRIVETRAIN
A remanufactured automatic transmission supplied by ATC Drivetrain is installed in an APPLIED VEHICLE AND
CONSULT-III plus (C-III plus) is not able to communicate with the TCM through Diagnosis (One System) OR
C-III plus is able to communicate with the TCM, but the TCM part numbers (P/N) sixth digit is a 5, 6, or 7 (for example, 31020-7xxxx).
VARIOUS NISSAN; SERVICING RUN FLAT TIRES AND LOW PROFILE TIRES EQUIPPED WITH TPMS SENSORS
When servicing run flat tires or low profile tires:
Special equipment and procedures are required to avoid damage.
Specifically, Tire Pressure Monitor transmitters (TPMS sensors) can be damaged when improperly dismounting and mounting tires.
TPMS sensors becoming damaged during mounting or dismounting tires are not covered under warranty.
To avoid such damage, ensure that the tire changer being used and the operator of the tire changer are capable of servicing run flat and low profile tires.
2005-2015 ALL NISSAN MODELS; ECM REPROGRAMMING SERVICE INFORMATION
After ECM reprogramming, the Calibration Verification Number (CVN) needs to be automatically calculated prior to State emissions testing (also known as Inspection Maintainence, I/M, or SMOG testing depending upon location). Allowing the vehicle to idle for 22 minutes will allow for faster CVN calculation. It is recommended that customers utilize this method if the vehicle needs to be tested for emissions soon after ECM reprogramming.
-REVISED- 2005-2008 NISSAN PATHFINDER, FRONTIER, XTERRA WITH V6 ENGINE; SPECIAL INSTRUCTIONS FOR INSTALLING REMANUFACTURED A/T FROM ATC DRIVETRAIN
The automatic transmission needs to be replaced, for any reason, in an applied vehicle
VARIOUS NISSAN MODLES; PRECAUTIONS FOR CLEANING PAINTED ALLOY WHEELS
The appearance of painted alloy wheels can be damaged if acidic cleaners are used.