350Z interior light problems

[Smittyhoss]

I jumped my car because i left the lights on like an idiot. and when i jumped it the interior lights stopped working. Has anyone replaced them if so, is it difficult?

[vpnavy]

Interior lights - are you talking about just your dome light? Is your instrument panel, etc. still work? In the meantime, check all your fuses.

[Smittyhoss]

Im sorry for being broad but the dome lights on the center of the roof of the car just stopped working, do you know how to replace them? if so is it difficult

[vpnavy]

Originally Posted by Smittyhoss

Im sorry for being broad but the dome lights on the center of the roof of the car just stopped working, do you know how to replace them? if so is it difficult

No problem. I pulled this from your Owner's Manual.

Hope this helps...

[vcline]

I am having same issue after jump start and NONE of the interior lights (dome, mirror, or door) are working. Instrument panel is fine.

Have checked fuses nd all fine

[timely]

I did the same thing. after a lot of research I found out how to reset my interior lights.

Open both doors on your 350Z and remove the the negative cable on your battery for 5 minutes. than reconect the battery connector and your lights should be on. This will reset a sensor in the BMC

If not or it happens again you will need a new BCM ( body control module ) this is installed by a dealler and you need to bring all of your keys for new key codes



Timely

[vcline]

Worked like a charm

Thank you VERY much !!!

[xterramexico05]

tip.... your battery died and depending on the hours it was dead, when you finally jumped started the Z, your ECU was officially under air/fuel re-learning procedure.... wich means that you must drive with 2,000 and under rpm's and go on freeway at 60 mph for 30 minutes while air/fuel mixture is adjusted...


if you did not know this, your engine will be running rich and you will not know it untill your Pcode for Cat low bla bla bla ....


you will need to disconect your battery for 30 minutes, re-connect and do the low rpm's procedure with open flat highway for air/fuel mixture to be close to perfect..