#1
|
|||
|
|||
Brake controller in 10 pro4x
I'm trying to install a brake controller in a 2010 Titan pro4x. It's an aftermarket controller, and I'm trying to attach to the factory tow package wiring under the dash. The controller output is blue, and I can't find a solid answer as to which one that goes to in the factory harness. At the back, there is a7 pin plug already installed, and a blue wire attached for brakes. It looks like factory wiring possibly, going to the plug. It's not my truck, and we don't know history. Going by gauge, there is a larger gauge wire in the harness at the front, Brown with white tracer. The other three wires were the power and ground, and red with a grey tracer for brake input. Confirmed by checking the wires at the brake switch. There's also the red with blue tracer as illumination but that isn't used.
I'd love a fsm on it, but I can't find one yet. Does anyone have any input on this wiring? |
#2
|
||||
|
||||
Try Nico Club's site; they have free, factory service manuals for Nissans. I'm not sure about the Titans, but my R51 Pathfinders were all plug and play. I got a Tekonsha P3 controller with a harness that was made with a factory-type connector that plugged right into the white trailer brake connector under the driver's side of the dash and I had to get a trailer relay from Nissan and plug it in. The 7-pin trailer plug was from Nissan and it simply "T" into the vehicle's main harness on the frame rail on the left-rear side of the truck. Mounted the controller and that was it.
Last edited by smj999smj; 04-07-2019 at 10:26 PM. |
Tags |
brake, controller, pro4x |
Thread Tools | |
Display Modes | |
|
|