 |
|
|
|
10-20-2008, 03:22 PM
|
||||
|
||||
2001 Nissan Sentra GXE
I have a 01 Sentra that would not start. It just happen all of suddenly. I have check the fuse & spark plugs. The plugs are good and the fues are good. I've test the spark, it does not have spark. Also, fuel injector is not working either. So I replaced the Crank & Camshaft Sensor. It cranks, but it would not turn over. The fuel pressure seems to be good and I don't know what else could be the problem.
Any help would be appriciated... Mike     
|
|
10-20-2008, 03:45 PM
|
||||
|
||||
|
well im guessing your problem is te spark since u said when u tested it u didnt get a spark, either coil or spark is the issue. no spark no start
__________________
 2002 Maxima GLE Silver on Black | Berk Intake w/AEM Dryflow | Clear Sidemarker Lights w/PIAA L.E.D|PIAA L.E.D Courtesy and Licence Plate Lights|PIAA White Fogs |Fibre Customs EyeLids | 5% Limo Tint | Brembo Blanks and Hawk HPS Pads |Ebay FSTB|CATTMAN RSB| NWP VIAS Block plate | OEM Spoiler | [ Parts To Be Installed ] Phenolic Thermal Intake Manifold Spacer Kit (waiting till 80k for spark plug change) 07 350 Rims (needs tires and 1 rim be fixed)
|
|
10-21-2008, 10:17 AM
|
||||
|
||||
|
By the way, this car is California Emission vehicle.
I did pull the code and hear are the list: p0302 cylinder 2 misfire p0340 camshaft position a circuit p1441 evap small leak I did have the check engine light on for awhile, but it never cause the starting problem. The spark plug was recently replaced with NGK plug. When I tested the plugs with tester light, it would blink twice than it stops. Also, when I tested the fuel injectors, it does not work. I've check the signal feeding in & out from Crank sensor and it's working. However, the Camshaft sensor gets the power, but no signal comes out. I can't figure this out..... May be my ECU has a problem??? Many thanks Mike Last edited by mikekwon1970; 10-21-2008 at 02:27 PM.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
