Register | FAQ | Social Groups | Mark Forums Read |
#136
|
||||
|
||||
Just Check the part number Of your maf. If your oe.maf is the same as the 01 maf it should work.
|
#137
|
|||
|
|||
Do anyone of you need to replace the entire tube or just the sensor will do? I have the part and wondering? Tia
|
#138
|
|||
|
|||
Just an update, did not change the tube, just the sensor. Did not reset car or anything, P0171 was gone once the car started up. Thanks saved $$$
|
#139
|
|||
|
|||
01Pathfinder MAF
01 Pathfinder pulled codes P 100 (Replaced); P1140 Bank1 (Replaced cam position sensor); P0505?? Car will start and idle drive down the road hit 2200 rpm then sputters will stall if you don't take foot of gas peddle. Can drive a while then stop and turn car off. Try and start again wont start seems like not getting enough fuel. Remove MAF and car will start no problem. Very confused any ides??
|
#140
|
||||
|
||||
It sounds like you may need to relearn the idle air volume. Refer to this TSB:
http://x.nissanhelp.com/forums/local...p=10&keyid=586 |
Tags |
2001, airflow, mass, pathfinder, sensor |
Thread Tools | |
Display Modes | |
|
|