http://x.nissanhelp.com/forums/ en Sat, 21 Nov 2009 07:34:49 GMT vBulletin 60 http://x.nissanhelp.com/forums/images/misc/rss.jpg http://x.nissanhelp.com/forums/ http://x.nissanhelp.com/forums/pathfinder/13343-2008-pathy-v8-le-towing-4pin-7pin-conversion.html Fri, 20 Nov 2009 18:52:44 GMT If I buy the Receiver Hitch Tow Harness Kit (7pin) and install it on my 4 pin standard model - Will the power brake line be there to utilize in the... If I buy the Receiver Hitch Tow Harness Kit (7pin) and install it on my 4 pin standard model - Will the power brake line be there to utilize in the same location that the 4 pin harness is connected, or will the trailer dealer have to hard wire this from the electronic proportional brake controller? see:
Receiver Hitch, Tow Harness Kit (7-Pin) - 2008 to 2009 Pathfinder :: Nissan Parts, NISMO and Nissan Accessories - Courtesyparts.com

What I'm asking is what gets connected to the other 3 connectors in the 7 pin and where are these connectors/wires located?


I know that there is also an adapter to install from vehicle brakes to trailer brakes. Does anyone know definitivly whether or not I have to buy an additional relay. The site referenced below only indicates this for certain 2006 models. see:
Nissan Wiring Harness - Vehicle Brakes to Trailer Brakes :: Nissan Parts, NISMO and Nissan Accessories - Courtesyparts.com


Thanks ]]> Pathfinder Deepcat1 http://x.nissanhelp.com/forums/pathfinder/13343-2008-pathy-v8-le-towing-4pin-7pin-conversion.html http://x.nissanhelp.com/forums/pathfinder/13335-gas-milage.html Fri, 20 Nov 2009 01:54:50 GMT Hi I have 1998 pathfinder crappy milage. Thinking about going to manual hubs? Sound good? Hi I have 1998 pathfinder crappy milage. Thinking about going to manual hubs? Sound good? ]]> Pathfinder muddy17 http://x.nissanhelp.com/forums/pathfinder/13335-gas-milage.html http://x.nissanhelp.com/forums/pathfinder/13334-05-pathy-hose-tranny.html Fri, 20 Nov 2009 00:02:54 GMT someone help me here.... i just found a tube/hose that is attached to the tranny on the driver side, and is running up and clipped to my airbox. Is... someone help me here.... i just found a tube/hose that is attached to the tranny on the driver side, and is running up and clipped to my airbox. Is that some kinda breather? Only one end is connected to the transmission and the other one doesnt connect to anything. It only hangs on the side of the air filter box. Is this where it's supposed to be? What is it for?

I am asking cuz i am planning on installing a Volant CAI on the truck and i dunno what this hose is for and where it should be ]]> Pathfinder Sappah http://x.nissanhelp.com/forums/pathfinder/13334-05-pathy-hose-tranny.html http://x.nissanhelp.com/forums/pathfinder/13331-02-pathy-wont-start-ticking-sound-w-o-key.html Thu, 19 Nov 2009 19:19:02 GMT Turned key this morning and nothing. Tried it again and it started. The a/c blower was going full blast and could not be controlled by the fan... Turned key this morning and nothing. Tried it again and it started. The a/c blower was going full blast and could not be controlled by the fan switch. I turned the car off and tried to start it again - nothing. The battery is good. There is a ticking noise coming from the fuse box under the hood; the "horn" fuse is ticking. There is also a clicking sound somewhere else (I can't locate it). All this is with the key out of the ignition. Any ideas? ]]> Pathfinder salsarev http://x.nissanhelp.com/forums/pathfinder/13331-02-pathy-wont-start-ticking-sound-w-o-key.html http://x.nissanhelp.com/forums/pathfinder/13327-failed-emission-test-88-pathfinder-help.html Thu, 19 Nov 2009 02:50:28 GMT In Oregon they call it DEQ, Dept Environrmental Quality. I failed, 244K runs great, fresh tune up, O2 sensor, filters. After driving it you can... In Oregon they call it DEQ, Dept Environrmental Quality.
I failed, 244K runs great, fresh tune up, O2 sensor, filters.
After driving it you can smell a fuel odor, when you get out after a drive,
Has throttle body injection. running way to rich.
So, what do you think, ???????????? ]]> Pathfinder Robb in LO http://x.nissanhelp.com/forums/pathfinder/13327-failed-emission-test-88-pathfinder-help.html http://x.nissanhelp.com/forums/pathfinder/13319-02-nissan-pathfinder-check-engine-light-code-p1456-p0456-very-small-evap-leak.html Wed, 18 Nov 2009 15:01:37 GMT I have a "02" nissan pathfinder with a check engine light and a code P1456/p0456 [very small evap leak]

Already Tried: replaced gas cap [didn't fix].

Uncertain if it the evap canister and vent valve or maybe the purge valve are bad. I don't know where the location of the purge valve! Need assistance.. ]]> Pathfinder Hakeem3484 http://x.nissanhelp.com/forums/pathfinder/13319-02-nissan-pathfinder-check-engine-light-code-p1456-p0456-very-small-evap-leak.html http://x.nissanhelp.com/forums/pathfinder/13316-rear-suspension-sag.html Wed, 18 Nov 2009 04:26:11 GMT i have a 05 le pathfinder 4x4. the rear stops are about 1.5 in from bottoming out. when i go over a bump it bottoms out, and on a bumpy road it... i have a 05 le pathfinder 4x4. the rear stops are about 1.5 in from bottoming out. when i go over a bump it bottoms out, and on a bumpy road it bounces. Im curently looking into some ranchos but im still not happy with the travel. is this a normal ride height? ]]> Pathfinder nassin00 http://x.nissanhelp.com/forums/pathfinder/13316-rear-suspension-sag.html http://x.nissanhelp.com/forums/pathfinder/13296-snaaaaaaaaaapped-lower-intake-stud-please-send-help.html Tue, 17 Nov 2009 00:05:15 GMT :mad:I just snapped the lower intake stud on my 1999 Nissan Pathfinder just as HolyJaguar did recently in this previous post. ... :mad:I just snapped the lower intake stud on my 1999 Nissan Pathfinder just as HolyJaguar did recently in this previous post.
http://x.nissanhelp.com/forums/frontier-hb-truck/11659-knock-sensor-replacement-snapped-4-lower-plenum-stud.html#post46848
Only the stud on my engine broke/ shattered lower and very jaggedly ! I spent $80 on a torque wrench, what a waste! I would have been better off without it. This was the first time that I used a torque wrench. I evenly torqued slow and steady from bolt #1 - #8 stepping up the foot pounds in small increments as stated in the Haynes repair manual. I never heard the "click" that the wrench is supposed to make or "felt the free play" as mentioned in the directions. I was nervously thinking, if I go any further the bolt will snap,then "SNAAAAAP"!
Thanks to a post in the above link from DarkPath, I know where to find a replacement, but should I ?
? # 1-Will the engine leak if I don't or will further damage occur if I don't fix it?
? # 2-What about the new gaskets that I just put on, can I re-use them? if so, do I now have to use RTV silicone on them? (I don't know if this matters, but the engine wasn't stated up, obviously).
? # 3-How are these bolts fastened to the block? Are they screwed in?
? # 4-Should I forget about using the torque wrench again and just make it good n' tight?
? # 5-Are the Lbs. specs crucial?
Thanks! ]]> Pathfinder RobSkydiver http://x.nissanhelp.com/forums/pathfinder/13296-snaaaaaaaaaapped-lower-intake-stud-please-send-help.html http://x.nissanhelp.com/forums/pathfinder/13272-1997-nissan-pathfinder-coil-spring-question.html Sat, 14 Nov 2009 14:47:14 GMT Hello, My pathfinders coil springs are ready to be replaced, but I refuse to spend the 500 bucks at the Nissan dealer, and for anyone who does own a... Hello, My pathfinders coil springs are ready to be replaced, but I refuse to spend the 500 bucks at the Nissan dealer, and for anyone who does own a 3rd gen pathfinder, aftermarket coils almost don't exist. Anyhow I have found a set of Old Man Emu coils that will raise the truck exactly .5 inches. Do I need to pair them with the Old Man Emu shocks (which might be longer traveling shocks)? Or will my practically brand new KYB gr-2's accomodate the larger spring?

Thank You ]]> Pathfinder gweinervt http://x.nissanhelp.com/forums/pathfinder/13272-1997-nissan-pathfinder-coil-spring-question.html http://x.nissanhelp.com/forums/pathfinder/13268-98-pathfinder.html Sat, 14 Nov 2009 03:21:37 GMT help with 4 wheel drive help with 4 wheel drive ]]> Pathfinder merlyn http://x.nissanhelp.com/forums/pathfinder/13268-98-pathfinder.html http://x.nissanhelp.com/forums/pathfinder/13263-1992-pathfinder-daylight-control-module.html Fri, 13 Nov 2009 18:45:07 GMT Hi My module quit, only one light comes on for daylights but headlights work normally, how do I bypass the module? I just want the lights to... Hi

My module quit, only one light comes on for daylights but headlights work normally, how do I bypass the module? I just want the lights to work, not worth replacing module.

Thanks :hmm: ]]> Pathfinder j_laing8ti4 http://x.nissanhelp.com/forums/pathfinder/13263-1992-pathfinder-daylight-control-module.html http://x.nissanhelp.com/forums/pathfinder/13231-car-changing-o2-codes-p1320-p0135-p0158.html Mon, 09 Nov 2009 21:22:22 GMT Hi, I bought my Pathfinder a few months ago and it just seems to be throwing up various codes. Initially I was getting P1320, and then a... Hi,

I bought my Pathfinder a few months ago and it just seems to be throwing up various codes.

Initially I was getting P1320, and then a couple of weeks ago it also started to throw out P0158

I thought I would give the car a quick service before starting to look into any of the codes so new oil, plugs filters clean coil connectors and a reset later still throws up codes

This time i'm still getting the P1320 but now i'm getting a P0135, the P0158 seems to have gone away and hasn't returned in over 500 miles (it was popping up within 5 minutes before my service)

Could the P1320 be confusing the 02 sensors?

i was thinking of looking at the Crankshaft Postition Sensor next, is this going to be the best place to start?

Any advice is welcome ]]> Pathfinder goalieadam http://x.nissanhelp.com/forums/pathfinder/13231-car-changing-o2-codes-p1320-p0135-p0158.html http://x.nissanhelp.com/forums/pathfinder/13222-round-thing-attached-muffler.html Mon, 09 Nov 2009 12:23:39 GMT 2001 pathfinder 3.5 with two wheel drive. Round thing hanging off the front of the muffler...what is it? 2001 pathfinder 3.5 with two wheel drive. Round thing hanging off the front of the muffler...what is it? ]]> Pathfinder Steve in Wichita http://x.nissanhelp.com/forums/pathfinder/13222-round-thing-attached-muffler.html http://x.nissanhelp.com/forums/pathfinder/13220-wipers-gone-mad.html Mon, 09 Nov 2009 00:25:30 GMT Hello, I have a 05 Pathfinder, and the other day my wipers started to act strange , When switched on they work for a while (say 40 wipes) then... Hello,

I have a 05 Pathfinder, and the other day my wipers started to act strange , When switched on they work for a while (say 40 wipes) then they stop dead in random areas of the windshield for say a minute or so and then they start going again.

Another problem is when i try to turn them off, they will not stop.

My mechanic has ran diagnostics on it and is able to make them work ok when commanded by diagnostic unit.

Relays appear to be ok.

there was a U1000 error listed.

any ideas ?? ]]> Pathfinder porridge http://x.nissanhelp.com/forums/pathfinder/13220-wipers-gone-mad.html http://x.nissanhelp.com/forums/pathfinder/13212-05-path-check-engine-vdc-light-wont-rev.html Sun, 08 Nov 2009 03:38:24 GMT I have had this problem happen a few times in the last few weeks. The check engine light and VDC light come on when I start the vehicle and it won't rev above 1800 rpm. When I turn it off and back on it had cleared in the past. Now it won't clear. ]]> Pathfinder big b http://x.nissanhelp.com/forums/pathfinder/13212-05-path-check-engine-vdc-light-wont-rev.html