VARIOUS NISSAN MODELS; INTELLIGENT KEY INITIALIZATION PROCEDURE STOPS OR WILL NOT CONTINUE
When the initialization procedure being performed with a new or existing Intelligent Key to an applied vehicle is interrupted (the procedure stops or will not continue), the BCM may be left in learn mode and will not function until it returns to normal mode. Under this condition, the BCM and Intelligent Key(s) will not function normally. If this condition occurs, the BCM must be returned to normal mode and the initialization procedure started over.
-REVISED- ALL NISSAN MODELS; WINDOW GLASS WARRANTY INFORMATION
Nissan North America (NNA) is not responsible for damage to vehicle window glass that is a result of objects striking or scratching the glass; this includes damage caused by the installation of aftermarket window tinting. Damage of this type is not warrantable. Also, foreign material on the windshield surface is not a warrantable condition.
VARIOUS NISSAN MODELS; INTELLIGENT KEY IDENTIFICATION AND REGISTRATION TIPS
When replacing or adding an Intelligent Key, it is very important to make sure the correct Intelligent Key is selected from the parts department.
-REVISED- VARIOUS NISSAN MODELS; REVISED WHEEL ALIGNMENT SPECIFICATIONS
For the Applied Vehicles, some wheel alignment specifications listed in the Front Suspension (FSU) and Rear Suspension (RSU) sections of the Electronic Service Manual (ESM) have been revised.
2016-2017 NISSAN MAXIMA, ALTIMA; POP/CLUNK NOISE FROM REAR WHEN DRIVING OVER BUMPS
A pop or clunk noise from the rear of the vehicle, especially when driving over bumps,
AND
The rear suspention connecting rod nuts are found to be loose on the left and/or right side.
-REVISED- 2013–2017 NISSAN ALTIMA, PATHFINDER;
SHIFT LOCK SOLENOID REMOVAL AND INSTALLATION
If an Applied Vehicle needs the shift lock solenoid replaced for any reason, use the Service
Procedure in this bulletin.
2013-2017 NISSAN ALTIMA, 2014-2017 ROGUE; MIL ON WITH DTC P2004 STORED
MIL is ON with P2004 (INTAKE MANIFOLD RUNNER CONTROL VALVE POSITION SENSOR) stored.
-REVISED- VARIOUS NISSAN MODELS; OIL LEAKING AROUND VALVE TIMING CONTROL SOLENOID VALVE
Engine oil is leaking from a valve timing control solenoid valve,
And
The valve timing control solenoid valve operates correctly and is not externally damaged.
VARIOUS NISSAN MODELS; DTC P0036 DIAGNOSTIC INFORMATION
The Electronic Service Manual (ESM) information for DTC P0036 may be inaccurate or incomplete for the Applied Vehicles.
If an Applied Vehicle stores a DTC P0036, follow diagnostic procedures in the ESM for Bank 2 A/F Sensor Heater open or shorted.