Quote:
Originally Posted by mpe235
The wiring and relays in the passenger kick panel should be the same for either harness. Just install the rear portion. When you get done just check to make sure you have 12 volts at the pin in the connector. If you don't you should just need to install a relay in the existing harness in the kick panel. The brake controller plugs in under the dash. There should only be one connector that it can plug into. Be sure to follow the diagram supplied with the brake controller to wire it to the nissan plug. The colors are not always the same. There is no need to disconnect the battery.
|
There is no power to my 12v pin in the connector. Is there a needed relay for the '12 Pathfinder? The trailer brakes work fine, but no 12 v.