View Single Post
 
Old 11-20-2011, 11:11 PM
93SentraXE1.6L
Guest
 
Posts: n/a
Default

Get a volt meter and check the speaker connections at the stereo. You should get a 2 - 4 ohm reading. If you dont get a reading the speakers are blown or you have a factory amp


You could always pop off the front door panel and check the condition of the speaker and check for continuity with a volt meter to verify if it was good or bad.

If you had a factory amp it would be in the rear of the pathy on either the left or right underneath the back rear panels in the very back area.. If there is an amp there you would need to by pass it to get all the speakers to work.

Good Luck!
Reply With Quote