View Single Post
 
Old 12-22-2010, 04:35 PM
Blaxima95
Guest
 
Posts: n/a
Default

Quote:
Originally Posted by geanrofiscalini View Post
somebody must it seing this before a costumer came to the shop 01 maxima with p1320 and p0306 ok check it out coil 6 not working so according to nissan tsb we did all 6 coils and plugs car ranned fine for two months costumer comes back saying that is missing again so with out hesitation replaced all coils and it kept doing it so we scannded p1320 p0300 m ok check signal and everythings is there power, ground and the third one from the ecm its missing and at that time all 3 cilynders in bank 2 2 4 6 stop working car runs on back cilynders check crank sensor reff crank sensor poss and cam sensor ignition condenser they al passed and still got all neww sensors and still no signal to the coils from the computer even took timming cover off what a b thi nking it had jump timing and again everthing its fine there check continuinty on wires from computer to coils check fine bottom line replaced everything exept ecm please help
Hey it's Blaxima again and forgot to add another tip to mention of ur P1320 ign.1 problem,Did you check fuel rail pressure? Low fuel pressure will trigger this dtc also w/a P0300 code too! Disconnect vacuum line from fuel
regulator and plug it,Then on ign. and test fuel pressure
there should be around 40psi. Any lwr. than that replace
fuel pump. O! and did you try replacing all six injectors?
These are known commonly to eat injectors like crazy due to it's side feed design.It overheats over time.
Reply With Quote