View Single Post
 
Old 01-26-2007, 05:34 PM
mpe235's Avatar
mpe235 mpe235 is offline
Moderator
2015 Rogue
 
Join Date: Jun 2006
Location: New York
Posts: 5,530
Default

A common issue on this setup is the rear abs sensors. They go through a plastic cover and read off the wheel bearing. The housing that holds the plastic cover is aluminum and it corrodes. The corrosion causes the plastic cover to distort and it pushes the sensor down away from the sensor ring on the wheel bearing. To fix this you will need to remove both rear wheel bearings and pop out the plastic covers. Use a file to make the hole in the cover larger. This will prevent the cover from contacting the sensor. Then reassemble.
DO NOT TRY TO REMOVE THE SENSORS! The bolts break very easily and are difficult to drill out of the aluminum housing.

Sometimes this will cause an internal failure of the abs pump due to it running constantly. Fix it asap. That part costs about $1200.00
__________________
Nissan Master certified Technician
Hybrid and GTR certified
EV certified
ASE Master Certified.
Reply With Quote