striking rod oil seal
I too have a striking rod oil seal that has become loose from the transmission case.
I tried reseating it by gently tapping around the perimeter, but was unable to drive it home.
I would like to use a conventional driver tool, but this requires freeing the shift yoke from the striking rod. I removed the rolling pin by hammering sideways with an appropriate drift pin. However, I cannot pull the yoke off of the striking rod. The space is too small to admit a wheel/gear puller.
Any ideas besides pulling the whole tranny?
BTW, the shop manual suggests that it's doable with the tranny still in the car.
|